Amazing Article About Refrigerator Repair in Queens
(And if you looking for The Best Appliance Repair Services Simply Call Us Today: (212) 300-2875 : ) )
Refrigerator Repair in Queens – The refrigerator unit is one of the most important pieces of equipment in a kitchen. For this reason, it is essential that the unit is properly maintained for maximum energy efficiency and to avoid unexpected repair of the refrigerator. The owner can do many of these tasks himself. However, a professional can conduct a thorough review of the unit to eliminate major problems. Here are some of the most important areas to check regularly:
DIY STEPS FOR FIXING YOUR REFRIGERATOR
A refrigerator that does not work at all can be extremely frustrating, especially if you need time to notice it. You may lose a lot of food in the process. Here are some notable troubleshooting problems;
- Lack of power
As fundamental as it may seem, start with the simplest possibility. Does the refrigerator work? It’s not just power outlets and switches, but also checking the circuit box and fuses. Also, make sure the extensions are in good working order. If the light in the refrigerator does not work, it just needs replacement.
It is possible that the bins and drain tubes are clogged, so check them.
Finally, although a handful of ice cubes in a drink is a necessity during the harshest periods of the summer, ice machines can be a real pain and cause all kinds of issues. Check the tube of the ice maker to ensure there is no blockage.
- Not cooling properly
The preferred temperature is between about 2 and 3 degrees C (or about 35-38 Fahrenheit). Something much higher and the food will spoil and become a health hazard. Something much lower and freezing becomes a problem.
To check the temperature settings of your refrigerator, look for your thermostat. It will look like an analog dial or a digital display.
If the temperature of your refrigerator is too high/low, your thermostat will likely be broken or covered. Make sure it is not clogged or covered and replace it if necessary.
Here are some further checks you can do yourself;
- Door seals
Always check that the door seals are in good condition. If the door seal is damaged or there are signs of peril, the cold air from the refrigerator can escape.
- Ice accretion
Ice build-up inside the refrigerator can inhibit heat transfer and reduce efficiency. Reduced efficiency leads to higher bills and a warmer fridge.
Defrosting your refrigerator regularly help avoid the following consequences.
- Dirty capacitor coil
One possibility for the refrigerator to not be cold enough is that the condenser coils are dirty. Like a radiator, the condenser must remain clean to dissipate the heat discharged from inside the refrigerator. The more dirty the coils become, the more they have to work hard to cool the
refrigerator. If they are too dirty, they will not be able to bring the temperature inside the refrigerator.
- Evaporator fan motor
The evaporator fan is a set of coils that all refrigerators have – depending on the make and model, they can have one or more. The function of the evaporator is to circulate the cold air in the refrigerator. If it does not work, it does not generate enough cold air for the refrigerator compartment. If there is only one evaporator, it will be on the side of the freezer, but the freezer could still cool down.
- Condenser fan motor
A possible symptom of the fact that the refrigerator is not cold enough is that there is something stuck in the condenser fan motor blade. This or the fan motor may be defective. Located under or at the rear of the refrigerator, the condenser fan motor is used to draw air over the condenser coils to cool them.
- Start relay
A small device attached to the side of the compressor, the start relay provides the power needed to start the compressor. A faulty starter relay will mean that the compressor cannot run and the refrigerator will not cool down. If it is faulty, the start relay must be replaced.
- Thermostat for temperature control
The thermostat has the versatile function of allowing enough cold air to flow through the evaporator fan, compressor and condenser fan. If the cooling system fans are running but the refrigerator is not cooling, it is recommended to check the thermostat.
- Compressor
A compressor is a motor that compresses the refrigerant and circulates it through the condenser coils and the evaporator. It is preferable to contact a professional to handle any compressor problems.
In conclusion, these troubleshooting techniques can be somewhat difficult for inexperienced persons. So as a last resort, you can always reach out to our support to handle any malfunction of your refrigerator.
Refrigerator Repair in Queens Just Call Us Now Today: (212) 300-2875
]]>

Telephone No.2123002875